TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
427-C1673
N OT E
2328 06
The following test procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear diagnostic codes when original diagnostic
code is corrected.
Ensure diagnostic code indicator is active and that diagnostic code is active.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(b) Observe ON/OFF status of
diagnostic code indicator.
(c) Disconnect dump anti-drift
1. If diagnostic code indicator remains
solenoid from wiring harness (WP
active and diagnostic code remains
0218 00).
active, go to Test 2.
2. If diagnostic code indicator is inactive,
repeat this test in order to verify failure.
Replace solenoid (WP 0195 00) or
replace wiring harness in question (WP
0197 00 thru WP 0201 00).