TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(c) Operate machine and use
1. If diagnostic code is active, exit this
2328 03 - Continued.
messenger to ensure CID 2328 FMI
procedure and perform this
03 is active (TM 5-3805-291-10).
troubleshooting procedure again. If
cause of diagnostic code is not found,
replace implement ECM (WP 0060 00).
2. If diagnostic code is not active, initial
diagnostic code was probably caused by
a poor electrical connection at one of
wiring harness connectors that was
disconnected and reconnected. Resume
normal machine operation.
427-C1673
N OT E
2328 05
The following test procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear diagnostic codes when original diagnostic
code is corrected.
Ensure diagnostic code indicator is active and that diagnostic code is active.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(b) Disconnect dump anti-drift
solenoid from wiring harness (WP
0218 00).