4
TM 5-3805-292-23
FIELD MAINTENANCE
-
BOOM OVERRIDE VALVE REPLACEMENT
0081
REMOVAL, CLEANING AND INSPECTION, INSTALLATION
INITIAL SETUP
Materials/Parts - Continued
Tools and Special Tools
0
0
Tool Kit, General Mechanic's (WP 0178, Item
Tag, Marker (WP 0179, Item 30)
0
33)
0
References
0
SATS (WP 0178, Item 30)
0
TM 5-3805-292-10
0
Materials/Parts
TM 5-3805-292-23P, Figure 49
0
0
Cap Set, Protective (WP 0179, Item 2)
0
Equipment Conditions
0
Cleaning Compound, Solvent, Type III (WP
Hydraulic pressure relieved (WP 0172)
0179, Item 3)
0
0
ROPS tilted (WP 0134)
Oil, Lubricating, OE/HDO-10 (WP 0179, Item
0
LH console removed (WP 0104)
16)
0
0
Rag, Wiping (WP 0179, Item 19)
Charging system protection
0
resistor removed (WP 0159)
0
Estimated Time to Complete
0
1.0 Hr
0
WARN I N G
When servicing this machne, performing maintenance, or disposing of hazardous
i
materials, consult your unit/local hazardous waste disposal center or safety office for local
regulatory guidance. If further information is needed, please contact The Army
Environmental Hotline at 1-800-872-3845.
DO NOT disconnect or remove any hydraulic system lines or fitting unless engine is shut
down and hydraulic system pressure has been relieved. Tighten all connections before
applying pressure. Escaping hydraulic fluid under pressure can penetrate the skin.
At operating temperature, hydraulic oil is hot.Allow hydraulic oil to cool before removing
any hydraulic fitting.
Hydraulic oil is very slippey. Immediately wipe up any spills.
r
To prevent injury to personnel, wear protective eye covering and gloves.
Failure to follow these warnings may result in injury or death to personnel.
C AU T I O N
Cap all hydraulic hose and line ends along with component connections during removal to
protect against contamination. Failure to follow this caution may result in damage to
equipment.
0081-1