6
TM 5-3805-292-23
FIELD MAINTENANCE
-
CONTROL HANDLES AND JOYSTICK VALVE REPLACEMENT
0084
REMOVAL, CLEANING AND INSPECTION, INSTALLATION
INITIAL SETUP
References
Tools and Special Tools
0
0
Tool Kit, General Mechanic's (WP 0178, Item
TM 5-3805-292-23P, Figures 48, 52
0
33)
0
Equipment Conditions
0
SATS (WP 0178, Item 30)
0
Machine parked on level ground (TM 5-3805-
Materials/Parts
292-10)
0
0
Cap Set, Protective (WP 0179, Item 2)
Console removed (WP 0104)
0
0
Cleaning Compound, Solvent, Type III (WP
ROPS tilted (WP 0134)
0
0179, Item 3)
Battery power disconnected (WP 0142)
0
0
Rag, Wiping (WP 0179, Item 19)
Hydraulic pressure relieved (WP 0172)
0
0
Tag, Marker (WP 0179, Item 30)
0
Estimated Time to Complete
0
2.1 Hr
0
WARN I N G
When servicing this machne, performing maintenance, or disposing of hazardous
i
materials, consult your unit/local hazardous waste disposal center or safety office for local
regulatory guidance. If further information is needed, please contact The Army
Environmental Hotline at 1-800-872-3845.
DO NOT disconnect or remove any hydraulic system lines or fitting unless engine is shut
down and hydraulic system pressure has been relieved. Tighten all connections before
applying pressure. Escaping hydraulic fluid under pressure can penetrate the skin.
At operating temperature, hydraulic oil is hot.Allow hydraulic oil to cool before removing
any hydraulic fitting.
To prevent injury to personnel, wear protective eye covering and gloves.
Failure to follow these warnings may result in injury or death to personnel.
N OT E
The following procedures are for the LH joystick valve. Use the same procedures for the
RH joystick valve.
0084-1