TM 5-3805-291-23-1
TROUBLESHOOTING SYMPTOM INDEX - CONTINUED
0007 00
Table 3. MID 082 Implement - Continued.
TROUBLE-
CID
SHOOTING
FMI
FAULT
PROCEDURE
CODE
DESCRIPTION
FAULT CONDITIONS/EFFECTS
PAGE
0590 14
Cat Data Link
This diagnostic code is recorded when the engine ECM is not sending
Communication with
the necessary parameters to the implement ECM at the proper rate. The
Engine EC Parameter
update rate for parameters that are generated by the engine ECM is not
Failure
correct. The communication failure may be due to disconnected
connectors or a faulty wiring harness. The possible causes of this
diagnostic code are:
The power train ECM has the incorrect soft-
ware installed.
The implement ECM ha the incorrect soft-
s
ware installed.
Incompatible software may be installed.
The fuse for the power train ECM may have
failed.
When this code is generated, some implement functions may not work
properly.
0967 09
Machine Application
This diagnostic code is recorded when the implement ECM receives
Abnormal Update
information from the monitoring system ECM and the information is
NOT correct. The possible causes of this diagnostic code are a problem
with the data link harness, the monitoring system is not operational, and
the monitoring system has not been programmed with the correct
application software.
N OT E
Other related diagnostic codes may cause this diagnostic code. Check
for other related diagnostic codes.
When this code is generated, if the ECM has never been flashed, all
implement functions will be disabled. There is a 10 second delay before
implement functions are active.
0967 12
Machine Application
This diagnostic code is recorded when the implement ECM is receiving
Bad Equipment or
the incorrect harness code information from the monitoring system. The
Component
possible causes for this diagnostic code are incorrect implement
software is installed and incorrect monitoring system software is
installed. When this code is generated, implement functions are
disabled.
0007 00-45
