TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(c) At wiring harness connector for
1. If resistance is less than 5 Ohms, go to
0352 03 - Continued.
sensor, measure resistance from
Test 3.
contact 2 to frame ground.
2. If resistance is greater than 5 Ohms,
ground circuit in wiring harness has
failed, replace wiring harness in question
(WP 0195 00 thru WP 0201 00).
3. Check wiring harness of position sensor
for open circuit.
(a) Turn engine start and battery
disconnect switches to ON position
(TM 5-3805-291-10).
(b) Disconnect wiring harness from
position sensor (WP 0219 00).
(c) At wiring harness connector for
sensor, connect a jumper wire
between contact 2 and contact 5.
(d) Disconnect wiring harness
connectors from implement ECM
(WP 0060 00).
(e) At wiring harness connector for
1. If resistance measurement is less than 5
implement ECM, measure
Ohms, go to Test 4.
resistance between contact J2-24
2. If resistance is greater than 5 Ohms, there
(wire H710-PK) and contact J1-26
is an open circuit in wiring harness.
(wire C214-BK).
Replace wiring harness in question (WP
0195 00 thru WP 0201 00).
4. Check wiring harness of position sensor
for short to +battery circuit.
(a) Turn engine start and battery
disconnect switches to OFF
position (TM 5-3805-291-10).
(b) Wiring harness remains
disconnected from position sensor.
Remove jumper wire that was
installed in Test 3.
(c) Wiring harness connectors remain
disconnected from implement
ECM.
0009 00-191