TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
427-C1654
N OT E
0352 03
The following procedure may create other diagnostic codes. Ignore these created
diagnostic codes and clear diagnostic codes when original diagnostic code is cor-
rected.
Ensure diagnostic code is active.
1. Check for power at sensor.
(a) Do not disconnect wiring harness
connector from sensor.
(b) Turn engine start and battery
disconnect switches to ON position
(TM 5-3805-291-10).
1. If resistance is less than 5 Ohms, go to
(c) At wiring harness connector for
Test 3.
sensor, measure voltage from
contact 1 to contact 2.
2. If resistance is greater than 5 Ohms,
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
2. Check for proper ground at sensor.
(a) Wiring harness remains connected
to sensor.
(b) Turn engine start and battery
disconnect switches to ON position
(TM 5-3805-291-10).