TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check wiring harness.
0352 04 - Continued.
(a) Sensor remains disconnected from
wiring harness.
(b) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(c) Disconnect wiring harness
implement ECM (WP 0060 00).
1. If resistance is greater than 5,000 Ohms,
(d) At wiring harness connector for
go to Test 3.
implement ECM, measure
resistance between connector J2-24 2. If resistance is less than 5,000 Ohms,
(wire H710-PK) and ground.
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
3. Check +battery circuit.
(a) Ensure engine start switch is in OFF
position (TM 5-3805-291-10).
(b) Connector for sensor remains
disconnected.
(c) Connector for implement ECM
remains disconnected.
1. If resistance is less than 5 Ohms, go to
(d) Measure resistance between fuse
Test 4.
and contact 1 at connector for
sensor.
2. If resistance is greater than 5 Ohms,
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
4. Check ground circuit.
(a) Ensure engine start switch is in OFF
position (TM 5-3805-291-10).
(b) Connector for sensor remains
disconnected. Connector for
implement ECM remains
disconnected.
1. If resistance is less than 5 Ohms, exit this
(c) Measure resistance between
procedure and repeat this
contact J1-26 at connector for
troubleshooting procedure. If cause of
implement ECM and contact 2 at
diagnostic code is not found, replace
connector for sensor.
implement ECM (WP 0060 00).
2. If resistance is greater than 5 Ohms,
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
0009 00-194
