TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
427-C1654
N OT E
0352 08
Ensure diagnostic code CID 0352 FMI 08 is active.
1. Check sensor.
(a) Observe ON/OFF status of
diagnostic code indicator.
(b) Disconnect wiring harness from
1. If diagnostic code indicator is active,
sensor.
sensor is not causing diagnostic code. Go
to Test 2.
2. If sensor has failed, replace sensor
joystick (WP 0219 00).
2. Check wiring harness.
(a) Sensor remains disconnected from
wiring harness.
(b) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(c) Disconnect wiring harness from
implement ECM (WP 0060 00).
(d) At wiring harness connector for
1. If resistance is greater than 5,000 Ohms,
sensor, measure resistance between
exit this procedure and repeat this
signal contact 5 (wire H710-PK)
troubleshooting procedure. If diagnostic
and ground.
code is not found, replace implement
ECM (WP 0060 00).
2. If resistance is less than 5,000 Ohms,
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
