TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(e) At wiring harness connector for
1. If voltage is approximately 5 DCV,
0356 03 - Continued.
solenoid, measure voltage from
solenoid has failed. Replace solenoid
implement ECM between contact 2
(WP 0218 00).
(wire H716-WH) and contact 1
2. If voltage is approximately battery
(wire E922-GN).
voltage, go to Test 2.
2. Check wiring harness.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
(b) Disconnect wiring harness from
implement ECM (WP 0060 00).
(c) Turn engine start switch to ON
position (TM 5-3805-291-10).
(d) At wiring harness connector for
1. If voltage is approximately battery
implement ECM, measure voltage
voltage, replace wiring harness in
between contact J-50 (wire H716-
question (WP 0195 00 thru WP 0201 00).
WH) and contact J1-52 (wire E922- 2. If voltage is approximately 0 DCV, go to
GN).
Test 3.
3. Check if diagnostic code remains active.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
(b) Disconnect and inspect all wiring
harness connectors and reconnect.
Refer to Electrical Connectors
Inspection (WP 0022 00) as
necessary.
(c) Turn engine start switch to ON
position (TM 5-3805-291-10).
(d) Operate machine and use
1. If diagnostic code is active, exit this
messenger to ensure diagnostic
procedure and repeat this
code is active (TM 5-3805-291-10).
troubleshooting procedure. If cause of
diagnostic code is not found, replace
implement ECM (WP 0060 00).
2. If diagnostic code is not active, initial
diagnostic code was probably caused by
poor electrical connection at wiring
harness connectors that was
disconnected and reconnected. Resume
normal machine operation.
0009 00-216
