TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(d) Observe ON/OFF status of
1. If diagnostic code indicator is inactive,
0355 13 - Continued.
diagnostic code indicator as lift arm
calibration corrected diagnostic code.
is fully raised and lowered.
Clear diagnostic code.
2. If diagnostic code indicator is active,
repeat calibration for main control valve.
Also, ensure diagnostic code indicator is
active for this diagnostic code. If cause is
not found, replace solenoid (WP 0218
00) and perform calibration again. If this
does not eliminate diagnostic code,
replace implement ECM (WP 0060 00).
427-C1658
N OT E
0356 03
All solenoid return lines connect to J1-50 (wire H716-WH) of implement ECM.
The following procedure may create other diagnostic codes. Ignore these created
diagnostic codes and clear diagnostic codes when original diagnostic code is cor-
rected.
Ensure diagnostic code is active and that diagnostic code indicator is active.
This test causes implement ECM to logan open circuit diagnostic code for this
solenoid. Clear this code from implement ECM after troubleshooting.
1. Check solenoid.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
(b) Disconnect dump solenoid from
wiring harness (WP 0218 00).
(c) Turn engine start switch to ON
position (TM 5-3805-291-10).
(d) Place direction lever in NEUTRAL
position.