TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. Check solenoid.
0355 06 - Continued.
(a) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(b) Observe ON/OFF status of
diagnostic code indicator.
(c) Disconnect lower solenoid from
1. If diagnostic code indicator remains
wiring harness (WP 0218 00).
active, harness or implement ECM has
failed. Go to Test 2.
2. If diagnostic code indicator is inactive,
solenoid valve or connecting wiring
harness has failed. Repeat this test to
verify failure. Replace solenoid or
connecting wiring harness in question
(WP 0195 00 thru WP 0201 00).
2. Check for shorted wiring harness.
(a) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(b) Solenoid valve remains
disconnected.
(c) Disconnect wiring harness from
implement ECM (WP 0060 00).
(d) At wiring harness connector for
1. If resistance is less than 5,000 Ohms
implement ECM, measure
(continuity), replace wiring harness in
resistance between contact for
question (WP 0195 00 thru WP 0201 00).
failed solenoid circuit J1-49 (wire
2. If resistance is greater than 5,000 Ohms
H714-OR) and contact J1-50
(no continuity), exit this procedure and
(ground) (wire H716-WH).
repeat this troubleshooting procedure.
Also, recheck if diagnostic code
indicator is active for this diagnostic
code. If cause is not found, replace
implement ECM (WP 0060 00).
N OT E
0355 13
Ensure diagnostic code is active and diagnostic code indicator is
active.
Check calibration of main control valve.
(a) Calibrate main control valve (WP
(b) Recheck diagnostic code.
(c) Ensure diagnostic code is active.
