TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check wiring harness.
0355 05 - Continued.
(a) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(b) Remove jumper wire from contact
1 (wire H714-OR) to contact 2
(wire H716-WH).
(c) Reconnect solenoid valve to wiring
harness.
(d) Disconnect wiring harness from
implement ECM (WP 0060 00).
(e) At wiring harness connector for
1. If resistance is greater than 5,000 Ohms
implement ECM, measure
(no continuity), replace wiring harness in
resistance between contacts J1-50
question (WP 0195 00 thru WP 0201 00).
(wire H716-WH) and contact J1-49 2. If resistance is from 6 to 12 Ohms, wiring
(wire H714-OR).
harness circuit resistance is correct, exit
this procedure and repeat this
troubleshooting procedure. Also, ensure
diagnostic code indicator is active for this
diagnostic code. If cause is not found,
replace implement ECM (WP 0060 00).
427-C1657
N OT E
0355 06
All solenoid return lines connect to contact J1-50 (wire H716-WH) of implement
ECM.
The following procedure may create other diagnostic codes. Ignore these created
diagnostic codes and clear diagnostic codes when original diagnostic code is cor-
rected.
Ensure diagnostic code is active and diagnostic code indicator is active.
