TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(d) Observe ON/OFF status of
1. If diagnostic code indicator is inactive,
356 13 - Continued.
diagnostic code indicator as work
calibration corrected diagnostic code.
tool is tilted back fully and work
Clear diagnostic code
tool is dumped.
2. If diagnostic code indicator is active,
perform calibration for main control
valve again. Also, ensure diagnostic code
indicator is active for this diagnostic
code. If cause is not found, replace
solenoid (WP 0218 00) and repeat
calibration. If this does not eliminate
diagnostic code, replace implement
ECM (WP 0060 00).
427-C1659
N OT E
0357 03
All solenoid return lines connect to contact J1-50 (wire H716-WH) of implement
ECM.
The following test procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear diagnostic codes when original diagnostic
code is corrected.
Ensure diagnostic code is active and diagnostic code indicator is active.
The following test causes implement EC to log an open circuit diagnostic code
M
for this solenoid. Clear this code from implement ECM after troubleshooting.
1. Check solenoid.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
(b) Disconnect rack solenoid from
wiring harness (WP 0218 00).
(c) Turn engine start switch to ON
position (TM 5-3805-291-10).
(d) Place direction lever in NEUTRAL
position.
