TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(b) Observe ON/OFF status of
0357 06 - Continued.
diagnostic code indicator.
1. If diagnostic code indicator remains
(c) Disconnect rack solenoid from
wiring harness (WP 0218 00).
active, harness or implement ECM has
failed. Go to Test 2.
2. If diagnostic code indicator is inactive,
solenoid or connecting harness has
failed. Repeat this test to verify failure.
Replace solenoid (WP 0218 00) or wiring
harness in question (WP 0195 00 thru
WP 0201 00).
2. Check for shorted wiring harness.
(a) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(b) Solenoid valve remains
disconnected.
(c) Disconnect wiring harness from
implement ECM (WP 0060 00).
(d) At wiring harness connector for
1. If resistance is less than 5,000 Ohms,
implement ECM, measure
harness has failed. Replace wiring
resistance between contact to failed
harness in question (WP 0195 00 thru
solenoid circuit J1-51 (wire E921-
WP 0201 00).
PK) and contact J1-50 (ground wire 2. If resistance is greater than 5,000 Ohms
H716-WH).
(no continuity), harness circuit resistance
is correct. Exit this procedure and repeat
this troubleshooting procedure. Also,
recheck if diagnostic code indicator is
active for this diagnostic code. If cause is
not found, replace implement ECM (WP
0060 00).
N OT E
0357 13
Ensure diagnostic code is active.
Check calibration of main control valve.
(a) Calibrate main control valve (WP
(b) Ensure diagnostic code is active.
1. If diagnostic indicator is inactive,
(c) Observe ON/OFF status of
calibration corrected diagnostic code.
diagnostic code as work tool is
Clear diagnostic code.
tilted back fully and work tool is
dumped.
