8
TM 5-3805-292-10
OPERATOR MAINTENANCE
-
CONFIGURING AND OPERATING HAMMER
0012
CONFIGURATION, OPERATION, REMOVAL
INITIAL SETUP
Tools and Special Tools
Personnel Required
0
0
Hammer (WP 0031, Table 2, Item 3)
Two
0
0
Pin Punch (WP 0031, Table 2, Item 4)
0
References
0
Lifting Device
0
0
0
INTRODUCTION
0012
WARNING
Be alert for personnel in the area while operating machine with work tools. Always check
to ensure area is clear of personnel and obstructions before moving.
Always use a ground guide when driving machine with work tools if visibility is impaired.
Personnel in the area must always wear eye protection while hammer is in operation.
Tamping attachment weighs 100 lb (45 kg). Take care when lifting to prevent injury.
DO NOT perform this task with engine running.
Failure to follow these warnings may result in injury or death to personnel or damage to
equipment.
1. Survey work site before operation to become familiar with job requirements and ground conditions.
2. When operating work tool, keep cab door closed.
END OF TASK
0012-1