TM 5-3805-292-10
0012
OPERATION
0012
CAUTION
DO NOT apply the tool with a side load. The tool must always be pressed firmly against,
and be perpendicular to the material to be broken.
Failure to comply can cause tool or seal failure.
Impact action must be stopped immediately when the object has been broken.
DO NOT pry with the tool.
Avoid continuous impact on the same area for more than one minute.
Break large objects from the outside edges and work inward.
DO NOT submerge the tool in water.
DO NOT use the tool to move very large or heavy broken objects, or as a lifting device.
DO NOT operate the tool when boom cylinders are at their extreme ends.
Stop operation immediately and notify Field Maintenance if hoses vibrate abnormally or
impact energy is reduced.
Failure to comply with this caution may result in damage to equipment.
1. Position hydraulic hammer height by moving RH (loader) control lever (Figure 5, Item 1) forward or backward.
2. Position hydraulic hammer angle by moving RH (loader) control lever (Figure 5, Item 1) left or right.
1
458-0309
Figure 5. Positioning Work Tool with RH (Loader) Control Lever.
0012