TM 5-3805-298-23-2
0155
Table 1. Kickout System Will Not Operate or Operates Improperly Continued.
0155
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 41. Test for Shorted Front
Kickout System Will Not
Frame Wiring Harness.
Operate or Operates
1. Turn ignition switch and battery
Improperly - Continued
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector LE-C1
(WP 0012, Figure 87) from
connector C-C10 (WP 0012,
Figure 86).
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
4. Set implement disable switch to
unlock position
(TM 5-3805-298-10).
5. Set kickout switch to ON position
(TM 5-3805-298-10).
6. Using digital multimeter
Voltage 0.5 V or Greater Replace
(WP 0174), test for voltage
lower cab wiring harness (WP 0291).
between connector C-C10
Proceed to Test Step 60.
terminal 2 (WP 0012, Figure 86)
Voltage Less Than 0.5 V Replace
and ground.
front frame wiring harness (WP 0301).
Proceed to Test Step 60.
Test Step 42. Test for Shorted
Solenoid Circuit to Fork Kickout
Position Sensor.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove two tiedown straps
(Figure 28, Item 3) from mounting
bracket (Figure 28, Item 1) and
wiring harness (Figure 28, Item 2).
Discard tiedown straps.
3. Disconnect connector N-C3 from
fork kickout position sensor
(WP 0012, Figure 234).
4. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
5. Set implement disable switch to
unlock position
(TM 5-3805-298-10).
6. Set kickout switch to ON position
(TM 5-3805-298-10).
0155-48