TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(d) At wiring harness connector for
1. If each resistance measurement is greater
0353 03 - Continued.
implement ECM, measure
than 5,000 Ohms, go to Test 5.
resistance from signal contact J2-
2. If one or more resistance measurements
25 (wire H711-GN) of wiring
is not correct, replace wiring harness in
harness to all possible sources of
question (WP 0195 00 thru WP 0201 00).
+battery circuit. Measure
resistance to all contacts used in J2
and J1 wiring harness connectors.
5. Check sensor output.
(a) Reconnect wiring harness
connectors to implement ECM.
Reconnect wiring harness
connector to sensor.
(b) At wiring harness connector for
sensor, connect positive lead from
multimeter to contact 3.
(c) At wiring harness connector for
sensor, connect negative lead from
multimeter to contact 2.
(d) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(e) Set multimeter to setting for
1. If PWM signal from sensor is a 500 Hz
frequency (Hz). Measure sensor
signal between 5% and 95%, go to Test 6.
output.
2. If PWM signal from sensor is not a 500
Hz signal, or signal is not between 5%
and 95%, replace joystick (WP 0219 00).
6. Check if diagnostic code remains active.
(a) Disconnect, inspect, and clean all
wiring harness connectors and
reconnect. Refer to Electrical
Connectors Inspection (WP 0022
00) as necessary.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
0009 00-200
