TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(c) Disconnect wiring harness from
0353 04 - Continued.
implement ECM (WP 0060 00).
(d) At wiring harness connector for
1. If resistance is greater than 5,000 Ohms,
implement ECM, measure
go to Test 3.
resistance between connector J2-25 2. If resistance is less than 5,000 Ohms,
(wire H711-GN) and ground.
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
3. Check +battery circuit.
(a) Ensure engine start switch is in OFF
position (TM 5-3805-291-10).
(b) Connector for sensor remains
disconnected. Connector for
implement ECM remains
disconnected.
(c) Measure resistance between fuse
1. If resistance is less than 5 Ohms, go to
and contact 1 at connector for
Test 4.
sensor.
2. If resistance is greater than 5 Ohms,
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
4. Check ground circuit.
(a) Ensure engine start switch is in OFF
position (TM 5-3805-291-10).
(b) Connector for sensor remains
disconnected. Connector for
implement ECM remains
disconnected.
(c) Measure resistance between
1. If resistance is less than 5 Ohms, exit this
contact J1-26 at connector for
procedure and repeat this
implement ECM and contact 2 at
troubleshooting procedure. If cause of
connector for sensor.
diagnostic code is not found, replace
implement ECM (WP 0060 00).
2. If resistance is greater than 5 Ohms,
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
0009 00-202
