TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
427-C1656
N OT E
0354 05
The following procedure may create other diagnostic codes. Ignore these created
diagnostic codes. Clear these diagnostic codes when original code is corrected.
Ensure diagnostic code indicator is active and diagnostic code is active.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(b) Disconnect raise solenoid from
wiring harness (WP 0218 00).
(c) Observe ON/OFF status of
diagnostic code indicator.
(d) At wiring harness connector for
1. If diagnostic code indicator remains
solenoid, place a jumper wire
active, go to Test 2.
between contact 1 (wire H713-PK) 2. If diagnostic code indicator is inactive,
and contact 2 (wire H716-WH).
repeat this test in order to verify
diagnostic code. Replace solenoid or
harness at solenoid (WP 0218 00).
2. Check wiring harness.
(a) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(b) Remove jumper wire from contact
1 (wire H713-PK) to contact 2 (wire
H716-WH).