TM 5-3805-290-23-1
TROUBLESHOOTING SYMPTOM INDEX - CONTINUED
0007 00
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
MACHINE ECM - CONTINUED
0007 00
Table 2. MID 081 - Machine Control System - Continued.
TROUBLE-
CID
SHOOTING
FMI
FAULT
PROCEDURE
CODE
DESCRIPTION
FAULT CONDITIONS/EFFECTS
PAGE
0795 07
Relay (Secondary
CID 0795 FMI 07 diagnostic code can only be recorded if optional
Steering Intermediate)
secondary steering system is installed and machine is moving. ECM
Mechanical System Not
determines machine is moving via transmission output speed sensor.
Responding Properly.
CID 0795 FMI 07 diagnostic code can only be recorded when ECM is
energizing secondary steering relay. Secondary steering relay energizes
an additional relay at secondary steering motor. This additional relay
provides power to motor. ECM monitors relay status at motor. If this
relay is not energized when secondary steering relay is energized,
diagnostic code is recorded. When machine is at rest, this diagnostic
code will always be inactive.
0811 09
Gage Cluster #1
This diagnostic code is recorded when machine ECM does not receive
Abnormal Update.
expected information from dash panel cluster for a period of more than
five seconds.
0826 03
Temperature Sensor
This diagnostic code is recorded when ECM reads torque converter oil
(Torque Converter Oil)
temperature sender signal voltage and voltage is too high. Possible
Voltage Above Normal.
causes of this diagnostic code are: sender has failed, sender return
circuit is open in machine harness, signal circuit in machine harness is
shorted to a source of positive voltage, signal circuit in machine harness
is open or sender is disconnected, or ECM has failed (such a failure is
unlikely). ECM will log diagnostic code.
0826 04
Temperature Sensor
This diagnostic code is recorded when ECM reads torque converter oil
(Torque Converter Oil)
temperature sender signal voltage and voltage is too low. Possible
Shorted to Ground.
causes of this failure are: sender has failed, signal circuit in machine
harness is shorted to ground, or ECM has failed (such a failure is
unlikely). ECM will log diagnostic code.
0882 03
Solenoid (Pilot ON/OFF) This diagnostic code is associated with implement lockout solenoid.
Voltage Above Normal. FMI 03 means ECM has determined solenoid circuit voltage is above
normal. Possible causes of this diagnostic code are: solenoid has failed,
solenoid energize circuit is shorted to +batt circuit, or ECM has failed
(such a failure is unlikely). ECM will log diagnostic code. When this
diagnostic code occurs, implements are locked.
0882 04
Solenoid (Pilot ON/OFF) This diagnostic code is associated with implement lockout solenoid.
Shorted to Ground.
FMI 04 means ECM has determined solenoid voltage is below normal.
Possible causes of this diagnostic code are: solenoid energize circuit is
shorted to ground, solenoid has failed, or ECM has failed (such a failure
is unlikely). ECM will log diagnostic code. When this diagnostic code
occurs, implements are locked.
0007 00-20
