TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. Check solenoid.
0354 06 - Continued.
(a) Turn battery disconnect and engine
start switches to ON position (TM
5-3805-291-10).
(b) Observe ON/OFF status of
diagnostic code indicator.
(c) Disconnect raise solenoid from
1. If diagnostic code indicator remains
wiring harness (WP 0218 00).
active, go to Test 2.
2. If diagnostic code indicator is inactive,
repeat this test to verify failure. Replace
solenoid or wiring harness in question
(WP 0195 00 thru WP 0201 00).
2. Check for shorted wiring harness.
(a) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(b) Solenoid valve remains
disconnected.
(c) Disconnect wiring harness from
implement ECM (WP 0060 00).
(d) At wiring harness connector for
1. If resistance is less than 5,000 Ohms
implement ECM, measure
(continuity), replace wiring harness in
resistance between contacts for
question (WP 0195 00 thru WP 0201 00).
solenoid with failed circuit contact
2. If resistance is greater than 5,000 Ohms
J1-48 (wire H713-PK) and J1-50
(no continuity), repeat this procedure.
(wire H716-WH).
Also, ensure diagnostic code indicator is
active for this diagnostic code. If cause is
not found, replace implement ECM (WP
0060 00).
N OT E
0354 13
Ensure diagnostic code indicator is active and diagnostic code is
active.
Check calibration of main control valve.
(a) Calibrate main control valve (WP
(b) Use messenger to recheck
diagnostic code (TM 5-3805-291-
10).
(c) Ensure diagnostic code is active.